"I recently bought a 24 ft. Ed
"I recently bought a 24 ft. Edgewater CC with a 1995 Yamaha 225 Saltwater series motor. The hole shot seems to have a good bit of acceleration up to about 4000 rpm. If I fiddle with the trim tabs, the boat will eventually nose over and come on plan. But WOT is only 4800 RPM when the boat is trimmed out at 30 MPH. The motor does not seem to missing or sputtering at any throttle position. Compression on all cylinders is 112-116. The motor is swinging a 14.5X15 stainless prop. I just replaced the 5/16 in. I/D fuel line that has 3 splice fittings with 1/4 in. I/D outlets with a new 3/8 line but have not yet water tested it. I noticed a on/off fuel valve at the bottom of the fuel pump line feed chain and it is in the off position. Is that correct? What does this valve control?"
"I recently bought a 24 ft. Edgewater CC with a 1995 Yamaha 225 Saltwater series motor. The hole shot seems to have a good bit of acceleration up to about 4000 rpm. If I fiddle with the trim tabs, the boat will eventually nose over and come on plan. But WOT is only 4800 RPM when the boat is trimmed out at 30 MPH. The motor does not seem to missing or sputtering at any throttle position. Compression on all cylinders is 112-116. The motor is swinging a 14.5X15 stainless prop. I just replaced the 5/16 in. I/D fuel line that has 3 splice fittings with 1/4 in. I/D outlets with a new 3/8 line but have not yet water tested it. I noticed a on/off fuel valve at the bottom of the fuel pump line feed chain and it is in the off position. Is that correct? What does this valve control?"