Logo
FULL SITE MENU

Water in lower unit 1999 25 mshx

M

mike_l

New member
Lower unit oil turning white.

Lower unit oil turning white. I got lower unit seal kit install it still turning white. I know there is water getting in but where at. Any help would be appreciate.
Tks. Mike
 
"pressure test sure is handy a

"pressure test sure is handy about now. if you properly installed seal kit, what is left? dont overlook the obvious. could be as simple as fill/level plugs."
 
Tks Scott

Tks Scott If I remember right I think I got new seals for the plugs and replace them. Its be a while since I install the kit. How much pressure do you use when you pressure test? As I didn't test it I thought I had it fixed.
Tks Mike
 
"pressure & vacuum testers

"pressure & vacuum testers would cost you more than having it done. pressure test at about 12 -14 psi if you can figure a way. look for bubbles with soapy water. is it losing fluid? how much time elapsed since re-seal? propshaft, water pump, shift shaft, plugs all resealed? be carefull not to overpressure. drain before testing"
 
okay Tks Scott for you help

okay Tks Scott for you help I will use fitting to fill lower unit and put rad. tester hose on fitting.
Tks very much appreciate
Mike
 
Back
Top