Logo

Diy ignition cut off switch

J

John Castle

Guest
I have a five hp Wards outboar

I have a five hp Wards outboard. I have to pull the choke out to kill it. Is there anyway to put a switch in to do this instead of using the choke?
 
"If you know how to do a littl

"If you know how to do a little wiring, you can make a kill switch by putting a momentary push on switch parallel with the wires going into the ignition coil, if only one wire, just put it between the wire and the block. The problem I see with useing the choke is that it can flood the engine and make restarting difficult. Setup an older(85 and the switch wiring was gone) snowblower with this and it still works to this day."
 
Back
Top