valkyrieridervrcc
New member
I noticed today while working
I noticed today while working on my 4hp 1991 Evinrude Motor that the brass fitting that the Needle valve goes into is missing. I guess its called the needle valve seat? Correct me if Im wrong here guys. But I definately think this is whats causing my problems with stalling out at higher RPM's. Also correct me if im wrong.
But I would like to know if that valve seat is included in a carb rebuilt kit or if I need to specifically order that piece seperately. Any insight you guys can give me would be greatly appreciated. Thanks
I noticed today while working on my 4hp 1991 Evinrude Motor that the brass fitting that the Needle valve goes into is missing. I guess its called the needle valve seat? Correct me if Im wrong here guys. But I definately think this is whats causing my problems with stalling out at higher RPM's. Also correct me if im wrong.
But I would like to know if that valve seat is included in a carb rebuilt kit or if I need to specifically order that piece seperately. Any insight you guys can give me would be greatly appreciated. Thanks