J
Joe Prochaska
Guest
I am about to change a cracked
I am about to change a cracked intake manifold on a 2003 4.3 GL / C. I'm hoping someone can provide help with the following three questions. 1. Torq setting for intake bolts. 2. Why is there gasket sealer applied only to the front and rear contact point (from factory)noticed after I removed the old one. 3. Since I had to remove the distributor I accidently spun the gear on it after it was out of the motor I hope to find directions to reset this in the new manifold. Thanks I'm having to do this myself for lack of funds so any help is appreciated.
I am about to change a cracked intake manifold on a 2003 4.3 GL / C. I'm hoping someone can provide help with the following three questions. 1. Torq setting for intake bolts. 2. Why is there gasket sealer applied only to the front and rear contact point (from factory)noticed after I removed the old one. 3. Since I had to remove the distributor I accidently spun the gear on it after it was out of the motor I hope to find directions to reset this in the new manifold. Thanks I'm having to do this myself for lack of funds so any help is appreciated.